Craftsman 113.299142 Owner's Manual download pdf (Page 32)

45° POSITION

TILT blade to LEFT as far as it will go. It will stop when"_

the PIVOT NUT is against the 45 ° STOP COLLAR ... and

the pointer SHOULD POINT to the "45" mark on the

bevel scale.

If POINTER DOES NOT POINT to the "'45" mark ... the

45° STOP COLLAR must be ADJUSTED.

I. Insert a medium screwdriver through the slot and

loosen BOTH setscrews in 45 ° STOP COLLAR. _ \

NOTE: If you can't reach the setscrews, turn the TILT \

crank slightly. \ _-_

2. Reach inside the saw from REAR ... ROTATE the

STOP COLLAR a few turns moving it toward the TILT

CRANK (to the left).

3. TILT blade until POINTER points to "45" mark.

4. ROTATE STOP COLLAR moving it to the right until it

stops... TIGHTEN the setsCrews.

TI LT MECHANISM

The crank should turn freely without binding. The turning

action can be adjusted by tightening or loosening the screws

in the bearing retainer.

NOTE: When adjusting the screws on the tilt crank, hold

the nut inside usinga 3/8 in, wrench.

TILT CRANK

ADJUSTTHESE

SCREWS

MAINTENANCE

WARNING: FOR YOUR OWN SAFETY, TURN SWITCH

"OFF" AND REMOVE PLUG FROM POWER SOURCE

OUTLET BEFORE MAINTAINING OR LUBRICATING

YOUR SAW.

Do not allow sawdust to accumulate inside the saw.

Frequently blow out any dust that may accumulate inside

the saw eebinet _nd the motor.

Frequently clean your cutting tools with Craftsman Gum

and Pitch Remover.

A coat of automobile-type wax applied to the table will

help to keep the surface clean and allow workpieces to slide

more freely. Treat unplated and unpainted steel parts and

surfaceswith Sears "Stop Rust.'"

f the power cord is worn or cut, or damaged in any way,

have it replaced immediately.

Make sure the teeth of the ANTIKICKBACK pawls are

always sharp. To sharpen:

1. Remove blade guard.

2. Rotate pawl towaro rear of spreader so that teeth are

above top of spreader.

3. Hold spreader with left I" and and place pawl over corner

of workbench.

4. Using a sma round file (Smooth Cut) sharpen the

teeth.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

Craftsman 113.299142 Owner's Manual Page 32

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.299142