Craftsman 113.299142 Owner's Manual download pdf (Page 10)

Lay REARFENCE GUIDE BAR on table to act as a

straightedge. If outer edge of extension ishigher or lower

than table surface;

A. Slightly loosen nuts holding bracket to extension

using 7/16 in. wrench.

B. Move end of extension up or down until outer edge

is even with table surface ... check with GUIDE

BAR ... tighten nuts.

C, Recheck INNER edge of extension to make sure it

hasnot moved ... readjust, if necessary,

INSTALLING RIP FENCE GUIDE BARS

I. From among the loose parts find the following

hardware:

2 Hex. Head Screws, 5/16 in. - 18 x 1-1/2 in. long

2 Hex. Head Screws, 5/16 in. - 18 x 1 in. long

4 Hex. Nuts, 5/16 in. - 18 (approx, dia. of hole 5/16

in.)

4 External Lockwashers, 5/16 in. (approx. dia. of hole

5/16 in.)

2 Spacers, 3/4 in. dia. x I/2 in. long

2 Self-threading nuts

2. Lay guide bars on table.

NOTE: The various holes in the bars allow them to be

repositioned on the saw and also makes them adaptable

to other models.

3. Insert 1-1/2 in. long screw through the THIRD hole

from the LEFT IN THE FRONT BAR ... insert

another 1-1/2 in. long screw through LARGE hole in

SWITCH BRACKET then through SEVENTH hole in

bar. Hold them in place with a piece of masking tape

from the underside.

4. Place spacerson screws.

Insert bolts through holes in middle and on right side of

front of saw table ... instal Iockwashers and nuts.

DON'T SCREW NUTS ON ALL THE WAY, just get

them started on the screws.

6. Remove the 3 screwsfrom rear of table extension.

7. Insert 1 in. long screws in SECOND and FOURTH holes

of rear bar and attach to tabSethe same way.

8. Insert ends of FENCE GUIDE BAR ROD through

round holes at outer end of bars.

NOTE: The ends of the ROD are not threaded ... the

SELF THREADING NUTS will cut threads on the rod

as they are screwed on.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comments to this Manuals

No comments

Craftsman 113.299142 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.299142