Craftsman 113.299142 Owner's Manual download pdf (Page 15)

1/4-20HEX

HD.SCREW

I/4 IN.LOCKWASHER

1./4-20HEXNUT

6. Slide SPREADER ROD into BLADE GUARD

SUPPORT until end of ROD is even with edge of

SUPPORT .. • Tighten Hex Head Screw in support,

7. Attach SPREADER to SPREADER SUPPORT so that

screws are all the way back in the SLOTS of SUPPORT

• .. tighten screws.

8• Raise ANTI-KICKBACK PAWL (hold it in place with a

piece of masking tape)

•.. align spreader SQUARE to table

•.. Tighten both HEX HEAD SCREWS.

END OF ROD

EVEIN WITH

OF SUPPORT

SCREWS ALL THE J

WAY BACK IN SLOTS

IN SUPPORT

9. Raise blade all the way up ... make sure it is square

with table•

10. Raise Blade Guard ... lift up bothANTI-KICKBACK

PAWLS ... insert one of the SETSCREW WRENCHES

in the notches to hold the pawls out of the way.

11. Lay blade of square or other straightedge alongside of

blade•

12. Loosen Hex Head Screw in BLADE GUARD SUPPORT

and move spreader so that i1 touches blade of square

•., tighten screw.

13. NOTE: The spreader is now square with the table and

approximately in line with the sawblade. The spreader

requires further adjustment to align it PARALLEL to

the blade and in the MIDDLE of the cut (KERF) made

by the sawblade•

14. IMPORTANT: The SPREADER must always be

PARALLEL to the sawblade and in the MIDDLE of the

cut (KERF) made by the sawblade.

NOTE: The spreader is thinner than the width of the

KERF by approximately six thicknesses of paper.

SPREA

SPACEEQUAL TO APPROX.

3 THICKNESSESOF PAPER KERF WOOD

BLADE

[

SPACE EQUAL TO APPROX. LOOKING DOWN ON SAW

3 THICKNESSES OF PAPER

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Comments to this Manuals

No comments

Craftsman 113.299142 Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.299142