Craftsman 113.299142 Owner's Manual download pdf (Page 16)

15. Make two folds in a small piece (6 x 6 in.) or ordinary

N EWSPAPE R making three thicknesses.

The folded paper will be used as a "'spacing gauge".

FOLDED PAPER

16. Place RIP FENCE on table ...

CAREFULLY move it against blade so that it is parallel

to the blade, and just TOUCHES tips of saw teeth ...

tighten RIP FENCE LOCK KNOB HANDLE.

17. Insert folded paper between SPREADER and FENCE

•.. bold spreader flat against fence ... tighten screws

using 7/16 in. wrench.

18. To remove BLADE GUARD AND SPREADER, loosen

THUMBSCREW ... DO NOT LOOSEN OTHER

SCREWS.

7/16

MOUNTING THE MOTOR

NOTE: Motor is included with Mode] 113.299040 and

113.298470•

CHECK MOTOR ROTATION

1. The motor must rotate CLOCKWISE when viewed from

the 5/8 in. shaft.

2. MAKE ,SURE "KEY" IS REMOVED FROM SHAFT.

3. Place the motor on your workbench or on the floor•

4. Stand clear of the motor and plug the cord into a

properly grounded outlet (See "Motor Specifications

and Electrical Requirements" Section) Notice the

rotation of the pulley. If it is not turning CLOCKWISE,

REMOVE the plug from the outlet, and change the

rotation of the motor according to the instructions

furnished with the motor.

ROTATION

/SIN. _:

DIA, SHAFT

WARNING: FOR YOUR OWN SAFETY, MAKE SURE

PLUG IS NOT CONNECTED TO POWER SOURCE

OUTLET WHEN CHANGING MOTOR ROTATION.

5. From among the loose parts, find the following

hardware:

4 Carriage Bolts, 5/16 in. - 18 x 3/4 in. long

4 Hex. Nuts, 5/16 in. - t8

(approx. dia. of hole 5/16 in.)

4 Lockwashers, 5/16 in. External Type

(approx. alia. of hole 5/16 in.)

6. Remove Blade Guard and Spreader.

7. Place motor on MOTOR BASE ... insert bolts through

holes in base ... then through the motor. Install

Iockwasbers, and nuts.

8. Position motor so that edge of MOTOR- FOOT and

MOTOR BASE are even .... slide motor all the way to

the RIGHT ... Lighten the four nuts.

g. Loosen set screw in motor pulley using 5/32 in.

setscrew wrench. Slide pulley on shaft with HUB away

from motor. DO NOT TIGHTEN SETSCREW.

10. Install 3/16 in. square key (furnished with motor) in

grooves in pulley and motor shaft. DO NOT TIGHTEN

SETSCREW.

LOCKWASHER THESE TWO CARRIAGE BOLT

5/16 IN. EDGES EVE_4 5/16-t8 X 3/4 "4.

NUT I

5/16-18 J.... j '_

GUARD

K_Y

BASE

MOTOR MOUNTING

BASE

ULLEY

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Comments to this Manuals

No comments

Craftsman 113.299142 Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.299142