Craftsman 113.299142 Owner's Manual download pdf (Page 14)

2. Attach REAR bar using SIXTH and EIGHTH holes in

bar.

NOTE: Remove screws from Table Extensions ... the ones

closest to the table. Reinstall them after attaching guide

bar. If extension is used on right side of saw, remove the

Guide Bar Rod.

t -J

/1 _/-- "----_

INSTALLING BLADE GUARD

1. From among the loose parts, find

2 Hex Head Screws, 1/4 in. - 20 x 5/8 in. long

2 Hex Head Screws, 5/16 in. - 18 x 5/8 in. long

2 Hex Head Screws, 5/16 in. - 16 x 1 in. long

2 Hex Nuts, 1/4 in, - 20

(approx. dia. of hole 1/4 in.)

2 Lockwashers, 1/4 in. External Type

(approx. dia. of hole 1/4 in.)

2 Lockwashers, 5/16 in. External Type

(approx. dia. of hole 5/16 in.} ....

1 Thumbscrew

Blade Guard Support

Spreader Support

Spreader Rod

2. Lower the blade.

3. Screw the two MOTOR MOUNT CLAMP SCREWS part

way into cradle.

4. Attach BLADE GUARD SUPPORT ... DO NOT

TI GHTEN screws.

LADE

Insert SPREADER ROD into SPREADER SUPPORT

until pin fits into notch. Insert Thumbscrew and tighten

it.

SPREADER

ROD

FLAT

SURFACE

(INTO SUPPORT)

SPREADER

SUPPORT

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

No comments

Craftsman 113.299142 Owner's Manual Page 14