Craftsman 113.299142 Owner's Manual download pdf (Page 28)

RESAWING

RESAWING is known as ripping a piece of wood through

its thickness. NOTE: To RESAW a piece of wood wider

than 3-3/8 in.... it will be necessary to remove the blade

guard ... and use the AUXILIARY FENCE/WORK

SUPPORT. [See "Work Helpers").

Do not attempt to resaw BOWED or WARPED material

Clamp it to the table so that the workpiece will SLIDE

EASILY but not TILT or MOVE SIDEWAYS without

BINDING between the two fences.

Do not clamp directly to the bottom edge of the table

because the "swivel" of the clamp will not grip properly.

Place a small block or wood between the bottom edge of

the table and the "'C" clamp.

WARNING: FOR YOUR OWN SAFETY ...

1. DO NOT "BACK UP" (REVERSE FEEDING) WHILE

R ESAWING BECAUSE THIS COULD CAUSE A

KICKBACK.

2. INSTALL BLADE GUARD IMMEDIATELY UPON

COMPLETION OF THE RESAWING OPERATION.

CUTTING PANELS

When cutting panels (whenever fence is positioned outside

of table surface), ALWAYS use the AUXILIARY

FENCE/WO R K SUPPORT. ._

1. Unlock fence and raise rear end.

2. Position AUXILIARY FENCE as shown and attach it

with two "'C'" clamps.

AU× LIARY FENCE/

RK SUPPORT

RABBETING

Rabbeting is known as cutting out a section of the corner

of a piece of material.

To make a RABBET requires two cuts which do not go all

the way through the material, Therefore the blade guard

must be removed.

1. Remove blade guard.

2. Adjust rip fence and blade to required dimensions.

3. Make first cut through edge. Follow resawing

procedure.

4. Remove auxiliary fence and make second cut.

5. INSTALL BLADE GUARD IMMEDIATELY UPON

COMPLETION OF RABBETING OPERATION.

Rabbet cuts can also be made using the dado head or

molding head.

RABBET

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Comments to this Manuals

No comments

Craftsman 113.299142 Owner's Manual Page 28

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.299142