Craftsman 113.299142 Owner's Manual download pdf (Page 18)

INSTALLING BELT GUARD

1. Remove the belt and motor pulley.

2. Screws furnished with guard are "self threading" ..

screw them into holes in BELT GUARD SUPPORT

BRACKET, then remove them.

3. Position BELT GUARD SUPPORT BRACKET and

BELT GUARD SUPPORT as shown and install the

screws ... make sure motor shaft is in CENTER of

hole in SUPPORT.

BELT GUARD

SUPPORT BRACKET

TWO HOLES CLOSEST

TOGETHER

10-32 X I/2 fIN

BELT GUARD SUPPORT

BELT GUARD

PIVOT

SCREW

CENT£RED

Install three CLIPS (furnished with guard) 90° apart

starting with one clip at the end of the guard asshown

•.. LONG END of clip facing AWAY from you.

BELT GUARD

OPENING

CLIPS

LONG END

5. Reinstall motor pulley the same way it was when you

aligned the belt.

6. Place belt on SAW'PULLEY ... insert end of belt

through opening in END of guard.

7. Slip belt over motor pulley.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

No comments

Craftsman 113.299142 Owner's Manual Page 18