Press guard onto support so that bottom of guard is
approximately 3/4 in. away from belt.
NOTE: To remove guard, lift up on LONG TABS of
cl ps ... pull guard outward. The clips should remain
on the BELT GUARD SUPPORT.
IN.
PLUGGING IN MOTOR
1. From among the loose parts, find two Pan Head Sheet
Metal Screws, 3/8 in. long, and two cord clamps.
2. Attach clamps to right side of saw cabinet.
3. Route motor cord and power cord inside of clamps.
4. Plug motor cord into outlet on back of switch box.
CORD CLAMPS
19
Comments to this Manuals