Craftsman 113.206933 Owner's Manual download pdf (Page 13)

b. Loosen 90° stop screw with small screwdriver

and turn knurled sleeve which will cause fence to

tilt, Turn sleeve in either direction until fence is

square with infeed table.

NOTE: If you cannot square fence by turning

knuded sleeve, loosen three screws "A" and

adjust fence square to table.

c. Tighten 90° stop Iockscrew and both fence lock

knobs,

d, If 90° reading on tilt scale does not line up with

top surface of the slide bracket, loosen screws

holding scale and move it... tighten screws.

45 = STOP

KNURLED J_

SLEEVEN_(

90 e STOP

e. Adjust 45° stop in the same manner.

NOTE: Tilt scale wilt not require adjustment if it

was adjusted for 90° position.

45_'STO_

90° STOP

HEAD

SQUARE

FENCE

SCALE

ADJUSTING

SCREW

_s o sToP

LOCKSCREW

TiLT

SCALE

'gO '_ STOP

LOCKSCREW

SCALE

AD3USTING

SCREW

BRACKET

INFEED

TABLE

CUTTER

GUARD

AUXILIARY FENCE

Some on-edge and other jointing operations require a

higher and/or Ionge rfence than you r tool provides. Select

a piece of smooth straight wood of the height and length

required for proper support and bolt it to the tool fence as

shown for these operations,

1/4-20 FLAT HEAD

SCREW COL

WARNING:

CUTTER GUARD. Provides protection over the

cutter head. It must always be in PlaCe and function-

ing properly. ....

Check the guard to make sure it is functioning

properly.

a. Position fence to right for maximum width of cut.

b. Pass a 1/4 in. thick piece of wood over cutterhead

between guard and fence,

Guard must return automatically to "rest position"

against fence when free of the wood,

tf guard does not return automatically, see Trouble

Shooting and Maintenance Sections.

CUTTER

GUARD

FENCE

INFEED TABLE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.206933 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.206933