Craftsman 113.206933 Owner's Manual download pdf (Page 9)

5. If a cutter blade adjustment is not required, check

each locking screw of each wedge (5/32" setscrew

wrench) and tighten if necessary. Hold the pulley

,i i --

MOUNTING SWITCH

1, Locate the following parts:

1 On/Off Power Outlet

2 Pan Hd. Screws, 1/4-20 x 1/2

while tightening screws and be careful that your

fingers do not slip off the wrench-

2 Lockwash_rS, IE;<te real 1/4

2 Washers, 17/64 × 1/2 x 1732

2. Attach On/Off out|et to infeed table using two _apped

holes.

i L __

INSTALLING MOTOR, PULLEY, V-BELT AND BELT

GUARDS

1. Locate the following parts:

QIy. Description

1 Motor

1 "L" Bracket

1 Pulley (Approx. 2-1/2" Dia.)

1 V=Belt 1/2 x 52

4 Carriage Bolt 5/16-18 x 3/4

4 Fiat Washer 5/16 i.D.

4 Lockwasher5/16 I.D.

4 Hex Nut 5/16-!8

1 Guard Assembly _nctuding a guard support,

guard support bracket, self-threading screws,

and clips,

2. Place motor against the motor mounting bracket and

insert bolts through holes in motor base and then

through holes marked "X" in motor mounting bracket.

DO NOT TIGHTEN BOLTS AT THiS TIME. The "L"

bracket which holds the guard support must be slid

between the motor base and the motor mounting

CARRIAGE BOLT

5/16-18 x 3/4

MOTOR ti

VtEW FROM BACK OF JOINTER

BOLTS GO THRU HOLES MARKED "X"

bracket somotor rn u st be loosely assembled to bracket

at this time.

iii, IH i, iiiiiiii, ii

(

3. Slide long leg of "L" bracket between motor base and

motor mounting bracket. Then sandwich the short leg

of the "L" bracket between the guard support bracket

and the guard support and loosely fasten together

with self-threading screws as shown. Install clips onto

bett guard support with long end of clip facing you.

L¸i_ j ill! i

TWO HOLES CLOSEST

10-32 X 1/2 IN,

SELF-THREADING

suP.oRT

i i i i !l , i iiiiii i _ url III

2"!/2 '° MOTOR PULLEY

4. Install the 2-1/2" pulley onto the motor shaft and

t_ghten the set screw in the pulley hub against the flat

part of the motor shaft.

5/32 INCH

SETSCREW TIGHTEN

WRENCH S_T SCREW

AGAINST FLAT

,ON SHAFT

HERE WITH

MOTOR SHAFT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.206933 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.206933