Craftsman 113.206933 Owner's Manual download pdf (Page 19)

BEVELING

Adjust the fence to the desired angle.., tighten fence and

guard lock knobs ......

For pieces of woo d 3" or wider hold the board firmlydown

on both tables and firmly against the fence (as illustrated)

with your hands on the side and top of the workpiece,..

keep finge_s close together.

NOTE: Removing only the corner on the edge of a board is

known as CHAMFERING while beveling is removing the

corner or the edge of the board down to the boards

surface.

Normally a chamfer is made with one cut,., therefore, a

cut deeper than 1/16 in. may be made,

For pieces of wood less than 3" wide use hold down/push

blocks (as illustrated) on the side of the workpiece so you

can hotd the workpiece in toward the fence at all times as

well as down against the table top.

WARNING: DO NOT CONTACT THE CUTTING KNIVES

OR THE GUARD WITH THE PUSH BLOCKS.

BEVELING BOARD WIDER THAN 3 INCHES

CHAMFER BEVEL

BEVELING BOARD NARROWER THAN 3 iNCHES

NOTE: Rabbeting on a Jointer is considered to be a

dangerous operation because it requires removal of the

cutter guard and increases the potential of kickback

because of excessive depth of cut .....

NEVER ATTEMPTTO PERFORM A RABBETING OPERA-

TION ON THIS JOINTER. DO NOT OPERATE JOtNTER/

PLANER WITH CUTTERHEAD OR BELT GUARDS

REMOVED.

Rabbet cuts should be made on the Radial Saw or Tabte

Saw by making two cuts with the sawblade or by using the

Dado Head or Molding Head. Rabbet cuts can also be

made using the Shaper or Portable Router.:

, i

maintenance

RABBETCUT

::i• IHUlhUlN ........

BLOCK OF WOOD

REPLACING CUTTER BLADES

WARNING: FOR YOUR OWN SAFETY, TURN SWITCH

"OFF" AND REMOVE PLUG FROM POWER SOURCE

OUTLET BEFORE ADJUSTING, MAINTAINING, OR

LUBRICATING YOUR JOINTER-PLANER,

1. Remove be!t guard.

2. Position fence to right ,.. approximately 1/4 in,

beyond cutter blades.., lock it in place,

3. Lower infeed table all the way down,

4. Place block of wood 6-3/4 in, long between cutter-

guard and fence:

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.206933 Owner's Manual Page 19

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.206933