Craftsman 113.206933 Owner's Manual download pdf (Page 21)

I/8 IN, SETSCREW WRENCH

10. Insert a blade in slot marked I .,. so it projects t/16 in.

beyond end of the cutterhead,

11. "Insert a wedge next to blade so the flat side of the

wedge is against the bla(_e. Push wedge in manually

-do not install two locking setscrews at this time."

!2, Place head of square on outfeed table. Loosen lifter

screws to raise blade until it just touches square and

slightly raises it. Gently turn cutter head back and

forth with the pulley while raising blade. The blades

should be adjusted just slightly above the cutfeed

table, by approximately .003 in. (thickness of an

average piece of paper).

NOTE: Sears has a knife setting gauge for this purpose.

Cat. #9-2647

HEAD OF

SQUARE ........

OUTFEED_

LIFTER SCREW

...... ii ,lllllr,i!iN,llll ii iii i

13. "Now install both locking setscrews and tighten (with

the 5/32" setscrew wrench) alternately a little at atime.

Tighten both screws securely. Recheck the blade to

make sure it did not change position."

14. Install other two blades the same way.

INFEE

INSTALLING CUTTER GUARD SPRING FLAT WASHER _zSPRtNG

t. Remove cotter pin from pivot pin in cutter guard and _"-'-_ !_ SUPPORT

remove guard (located u_derneath infeed table). _ LOCK _-_ 7"_PLATE

Spring must appear as in sketch from underside of infeed WASHE R_"_.._ /

table, it will not perform properly if nsta ed upside down. _ _ BUSHING

SCREW

VIEW LOOKING UP

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Craftsman 113.206933 Owner's Manual Page 21