Craftsman 113.206933 Owner's Manual download pdf (Page 10)

assembly ,

. 5/Push V_Belt through belt guard just enough to loop

. belt aro'uhd motor pulley_ Place bett: around m0t()r

pu ey but don0t push guard onto guard support at

: thistime. " - - -

6: Position other end of V-Belt onto cutter head pulley.

/ , i

7. Visually line up both pulleys and V-Belt until they are

perpendicular to the floor by sliding motor sideways

as needed,

8. Pressdown hard on motor to put tension on the V-Belt

and tighten the motor mounting bolts at this time.

9. Checkguard support before tightening guard support

screws to be sure itis centered around motor shaft and

will not rub against shaft when motor msrunning.

Tighten screws,

10. Push motor pulley belt guard into position onto guard

support.

tl. Plug motor cord into outlet on switch box installed

earlier through hole provided in stand.

12. Fasten cord along front side stiffener using the two

cord clips.

i i i

INSTALLING SLIDING GUARD

OPEN END

i i

PARTS NEEDED

1 Sliding Guard

1 Sliding Guard Knob

I Sliding Guard Rod

2 Sliding Guard Washers (one side of washer is concave)

2 Hex Hd. Screws 1/4-20x 1/2"

PULLEYS AND V-B ELT

j_MUST BE STRAIGHT IN-LINE

_AT 90° WITH RELATIONSHIP

C_____ TO THE FLOOR

t ,----V-BELT

GUARDS REMOVED

..... ! FOR PICTURE CLARITY

i, t STRAIGHT LNE

// _,] \ , UP--DOWN

90°

.... iJ, [ _

ill

2 Hex Nuts 1/4-20

1 Hex Nut 1/2 in. - 13

1 Split Iockwasher 1/2 in,

2 Ext. tooth Iockwashers

2 10-32 x 1/4 Pan Hd. Screws

1 Belt Guard

3, Screw the sliding guard rod into the jointer as far as it

witl go with the short end of rod pointing straight up.

4. Tighten the 1/2" nut to hold the rod securely in this

position.

_I,POsitiOn the siiding:guard rod through the opening in

the belt guard as illustrated. 1/2" LOCKWASHER

2. Screw 1/2 °' nut alt the way onto long end of rod... \_ BELT

place 1/2" Iockwasher next to nut (as illustrated), _/i/4_:_ _ GUARD

1/2" X t _/ .//_ \SLIDING

HEX NUT [i _/ GUARD ROD

1/2" HEX NUT

GUARD ROD

5. Attach guard to stand with hex hd. screws and nuts,

Make sure belt does not scrape guard,

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.206933 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.206933