Craftsman 113.206933 Owner's Manual download pdf (Page 8)

1. Place fence on jointer table as shown.

2_ Locate the following parts from the loose parts bag

and install as shown.

1. CarriageBolt, 3/8-16 x 24/2

2. Retainer

3, Fiat Washer 13/32 x 13/! 6 x 1/t6

4. Spacer

5. =Knob

1 2 JOINTER eASE

SPECIAL NOTE: It is a good _dea at this point to see ifthe

infeed table and Outfeed table are paraltel to each other. If

it is necessary to align the two tables the procedure used

to make them parallel can be more easily performed now,

before mounting the jointer/planer to the leg set, Refer to

page 14 for directions explaining how to check and align

the infeed and outfeed tables.

MOUNTING JOINTER-PLANER

1. From among the loose parts, find the following hard-

ware:

assembly

7 Lockwashers, 5/16 in. External Type

7 Washers, 11/32 ID

7 Hex Jam Nuts, 5/16-18

2 Cord Clips

2. Loosen FENCE LOCK KNOB, Tilt fence upward and

slide it toward the pulley.

3. Position machine on Leg Set and align mounting holer

in machine with holes in Leg Set letter coded "A'.

Mount with three (3) 5/16-18 x 2" Long Hex Head

Screws.

4. Place a flat washer, a tock washer and a nut on each

screw from underneath the stand and tighten.

5. Place handwheet on shaft aligning flat surfaces on

shaft with flat surfaces on handwheel.., attach with

1-1/4 in. screw.

_1_/ JOINTER ;PLANER

HEX HEAD SCREW

HEXNOTff'_ Jl

FENCE LOCK KNOB

4Carriage Bolts, 5/16-18 x 3/4

3 Hex Head Screws, 5/16-18 x 2

_/4-_0 TRUSS

HEAD SCREW SIDE STIFFENER

--- MOTOR SUPPORT AT THIS END

11 1

CHECKING CUTTER BLADES AND SCREWS

TOOLS NEEDED

5/32" and 1/8" Setscrew Wrenches (furnished with

Jointer).

Lead Pencil

FLAT WASHER

(AS REQUIRED) ..

LOCKWASHER

NUT ----"_

5/32 IN. SETSCREW

OUTFEED TABLE WRENCH

WEDGE

DEPTH OF CUT

Short straight edge (or head of combination square)

1. Insert pencil in space at end of cutterhead to hold

cutterhead guard open.

2. Lower the infeed table with the Depth of Cut Hand-

wheel.

3. Rest the straight edge on edge on the surface of

outfeed table so itextends across the opening between

the tables, at three positions: near each end and at the

middle of the cutter blade.

4. Rotate the cutterhead by grasping the 2" dia. driven

pulley and make sureeach knife nicks (touches) the

straight edge at all three positions. If not, follow

BLADE

PENCt L

CUTTER GUARD

procedure under "REPLACING CUTTER BLADES"

on pgs, 19 thru 21.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.206933 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.206933