Craftsman 113.206933 Owner's Manual download pdf (Page 12)

- = FENCE LOCKS AND STOPS.= The fence can be

moved across the Jointer to take full advantage of

1he "sharpness_' Of the blades.

Thb fence should be positioned to the extreme right

(toward pulley) but not beyond the end of the

blades.

Most of the cutting (usually jointing) will be done

-. w_th thefence in this position, As the blades become

• .dull, the fence can be moved toward the left where

the blades are sharper,

To move the fence, loosen the Fence Lock Knob and

the Sliding Guard Knob and slide to desired position.

Make sure SLIDE BRACKET is even with surface of

OUTFEED TAB LE. If it is above or below the surface,

loosen screws and adjust it.

a. Always tighten fence lock knob first to align

fence, then tighten sliding guard knob.

b. Before tightening fence lock knob, hold fence

down on outfeed table so it does not rock.

c. 90 ° Fence Stop positions fence square to tables.

TO tilt fence, loosen the fence lock knob and

sliding lock knob and pull the stop out. Tilt to

desired angle and tighten both knobs.

d. To set fence at g0 ° to tables, loosen the two

knobs, tilt fence so the stop springs back into

place. Tilt fence back so the stop rests on the

table and tighten both knobs.

e. 45 ° Fence Stop positions the fence at 45 ° to the

tables.

f. To tilt fence to 45 ° loosen the two knobs, pull 90 °

stop out, t It:fence so the 45 ° stop rests on the

table.

g. Ho d fencedown on outfeed table and tighten the

twokn0bs: " " : ' : :

i i i i ii i i

. FENCE TILT SCALE. Indicates tf_e angle of the

fence to the tables. When the 90_ fence stop is

correctly adjusted, the fence will be 90 ° to the table

and the scale will read 90 °.

To check for squareness, place an accurate square

PUSH DOWN

WHEN LOCKING

FENCE LOCK KNOB

FENCE

45°FENCE

STOf

_°FENCE

STOP

FENCE LOCK .

KNOB \

SLIDING GUARD KNOB

SLIDE BRACKET

._..---FENCE TILT SCALE

on infeed table and check fence while locked at 90°

position. MAKE SURE 90° STOP IS AGAINST SLIDE

BRACKET.

If fence is not square to table:

a. Slightly loosen fence lock knob and guard lock

knob ....

FENCE

FACE

SQUARE

" CUTTER

GUARD

1NFEED

TABLE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.206933 Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.206933