Craftsman 143.991200 Specifications download pdf (Page 36)

Assembly Procedure

NOTE: This procedure covers three starters. Follow

illustration of your starter type as shown.

1. Place the rewind spring and keeper assembly

into the pulley. Turn the pulley to lock into

position. A light coating of grease should be

on the spring.

2. Place the pulley assembly into the starter

housing.

3. Install the brake spring, starter dog(s), and

starter dog return spring(s). The starter dog

spring(s) must hold the dog(s) in against the

pulley.

4. Replace the retainer cup (cam dog on snow

proof starter) and retainer screw. Tighten to

65 - 75 in. lbs. (7-8.5 Nm) Older models that

use a 10 - 32 retainer screw can be replaced

with a larger 12 - 28 screw (part # 590409A).

Re-drill the screw hole using a 13/64"

(5.159 mm) drill bit. The center screw torque

on cast aluminum starters is 115 to 135 in.

lbs. (13-15 Nm) (diag. 11).

5. Tension the recoil spring by winding the pulley

counterclockwise until it becomes tight, then

allow the pulley to unwind until the hole in the

pulley lines up with the rope eyelet in the

starter housing. Install a knotted rope through

the pulley and the eyelet and install the

handle. A left-hand knot should be tied on the

end of the rope to secure the handle.

SPRING &

KEEPER ASSY.

HOUSING

PULLEY

DOG SPRNG

BRAKE SPRING

RETAINER

CENTER PIN

RETAINER SCREW

HANDLE

"STAMPED STEEL"

CENTER SCREW

HANDLE

PULLEY

BRAKE SPRING

HOUSING

CAM DOG

BRAKE WASHER

RETAINER

SPRING &

KEEPER

DOG SPRING

DOG

"ALUMINUM HOUSING"

STARTER HOUSING

SPRING PIN

BRAKE SPRING

HANDLE

DOG SPRING

STARTER DOG

ROPE

PULLEY

RETAINER SCREW

CAM DOG

WASHER

HANDLE

INSERT

DOG RETAINER

REWIND

SPRING AND

KEEPER

ASSY.

"STAMPED STEEL WITH ROLL PIN"

LEFT-HAND

KNOT

Main Menu

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 93 94

Comments to this Manuals

No comments

Craftsman 143.991200 Specifications Page 36

Comments to this Manuals