Craftsman 143.991200 Specifications download pdf (Page 30)

CONVERSION TO REMOTE CONTROL

Remove the manual control knob by squeezing together with a pliers or prying with a screw driver. Remove

the air cleaner cover and air cleaner element to gain easier access to the speed control lock nut that holds the

control levers together.

Remove the 3/8" (9.525 mm) locknut, bushing, wave washer, control lever, and the detent bearing plate.

Reassembly of REMOTE control.

Discard the detent bearing plate and in its place install the washer with the smaller I.D. from the new parts bag.

Install the lever over the post making sure that the end of the lever is in the slot of the control.

Place the other washer with the large I.D. from the parts bag next to lever, then the bushing. The smaller side

of the bushing goes towards the lever and fits inside of the lever and the washer.

Discard the wave washer.

Install the lock nut.

Check the alignment of the lever, bushing and washers to ensure that everything is aligned properly and

torque the lock nut to 20 in. lbs. (2 Nm).

The control lever should move freely.

This engine speed control is set up with the "stop in the control". If a remote stop is desired remove and

discard the short green wire that runs from the speed control grounding terminal (to the remote grommet stop

blade). Reinstall the blade and screw. It will now be necessary to run a grounding wire to a remote grounding

switch in order to stop the engine.

A remote grounding switch can be added to the engine at this terminal as well, thus allowing the engine to be

stopped at either the stop in the control or the remote grounding switch.

NOTE: THIS CONTROL IS STANDARD ON SERVICE ENGINES AND IS OPTIONAL TO CUSTOMERS

WASHER

CONTROL KNOB

ADDITION BOWDEN WIRE BRACKET

GROUNDING TERMINAL

SPEED CONTROL BRACKET

CONTROL LEVER

WAVE WASHER

LOCK NUT

BUSHING

SCREW

DETENT BEARING PLATE

CONDUIT CLIP

OHV11 - 17 SPEED CONTROL

OVM / OVXL GOVERNOR OVERRIDE

HIGH

SPEED

ADJUST

GOVERNED IDLE

ADJUST

Main Menu

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 93 94

No comments

Craftsman 143.991200 Specifications Page 30