Craftsman 113.241680 Owner's Manual download pdf (Page 13)

If blade is NOT SQUARE to table.., the 90° stop

screw must be ADJUSTED.

A. Unscrew 90° STOP SCREW three to four turns

using 3/16 in. setscrew wrench.

B. Turn tilt handwheel clockwiseoneturn, then turn

handwheel counterclockwise until blade is

square with table.

C. Screw 90° stop screw IN until it stops.., check

once again for squareness and readjust screw, if

necessary.

If blade is SQUARE to table:

A. Check pointer

JF POINTER DOES NOT point to the "O" mark on

the bevel scale:

A. Remove Elevation Handwheel.

B. Loosen pointer screw and adjust pointer using

medium screwdriver.

C. Reinstall Elevation Handwheel.

_POINTEk-_/ ADJUSTING S%REW _)

POINTER AT

"0" POSITION

NOTE: Lower sawblade elevation before tilting

sawblade. Failure to do this may result in damage to

your saw.

1. Lower the blade to about two inches above the

table.

2. Turn tilt handwheet counterclockwiseto tilt blade

to a 45 ° bevel.

3. Raise blade elevation to maximum height.

4. Check bevel of blade with the head of the

combination square.

HEAD OF

COMBINATION SQUARE

If blade is NOT 45 ° to table.., the 45 ° stop screw

must be ADJUSTED.

A Unscrew 45° STOP SCREWthree to four turns

using 3/16 in. setscrew wrench.

B. Turn tilt handwheel until blade is 45 ° to the table.

C. Screw 45° stop screw IN until it stops.., check

once again and readjust screw, if necessary.

5. Lower blade.

6. Tilt blade back to 90 ° ,

7. Tighten tilt lock handle.

8. Lower blade below table.

45 °

STOP SCREW

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Comments to this Manuals

No comments

Craftsman 113.241680 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.241680