Craftsman 113.241680 Owner's Manual download pdf (Page 21)

13, Raise blade a!! the way _p,

!4. Carefuiiy move fence against blade.

!5. Move front bar untit "0" mark on rip scale is

approximately in line with indicator.

16. Move FRONT bar upwards until fence is

approximately 1/32 in, above table., , tighten

screw at left end of bar,

NOTE; Fold a piece of newspaper making 8

thicknesses and place between rip fence and

table to act as a spacer• This will hold the fence

off of the table approx. 1/32 in

17. Adjust rear bar so that the fence is

approximateiy 1/32 in, above tab!e make sure

it is square with fence guide bar rod.., tighten

screw at end of bar.

t8. Replace screws in rear of table extension,., be

sure top surface of extension is PARALLEL to

top surface of rear guide bar.

19, Move fence to RIGHT edge of table , , , make

sure it is approx, t/32 in, above table at front and

rear and tighten screws,

ALIGNING RIP FENCE

The fence should slide easily along the bars and

always remain in alignment (parallel to sawblade

and miter gauge grooves).

The alignment is maintained by a spring underneath

the rip fence which bears against the front guide

bar.

To move the fence, loosen the lock handle and

grasp the fence with one hand at the front,

21 -"

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

No comments

Craftsman 113.241680 Owner's Manual Page 21