Craftsman 113.241680 Owner's Manual download pdf (Page 12)

.9. Using a wood block and hammerasshown, move

rear support bearing to right or left as required to

realign the blade. If necessary, shift front support

bearing in similar manner; but do NOT move front

support bearing unless necessary. Recheck the

alignment with the square, then securely

retighten all support bearing screws.

NOTE: Be certain that the Widest blade you use

does not contact blade insert after moving

support bearing. Check this at both 0°

(perpendicular to the table) and 45° bevel by

rotating the fully elevated blade by hand.

Readjust as required to maintain sufficient

clearance.

BLADE TILT, OR SQUARENESS OF

BLADE TO TABLE

90° (SQUARE) and 45° (BEVEL) STOP SCREWS.

When the bevel pointer is pointing directly to the

"O" mark on the bevel scale, the sawlolade should

make a SQUARE cut 90° to the table.

To check for SQUARENESS:

WARNING: TO AVOID INJURY FROM

ACCIDENTAL START, TURN SWITCH "OFF" AND

REMOVE PLUG FROM POWER SOURCE OUTLET.

1. Blade should be all the way UP.

2. Place the square against blade. Make sure square

is not touching the TIP of one of the saw TEETH.

_1 \\_

WOOD BLOCK

3. Turn the tilt-lock handle (COUNTER--

CLOCKWISE) to loosen the tilt clamp screw,.

4. NOTE: Handle is spring loaded for engagement

with screw head -- must be pushed inward for

disengagement whenever necessary to obtain a

new grip on screw head.

12 • •

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

No comments

Craftsman 113.241680 Owner's Manual Page 12