Craftsman 113.241680 Owner's Manual download pdf (Page 10)

iMPORTANT m Read Before Proceeding

Blade cannot be more than 2 inches above the table

top when tilting the sawblade to make bevel cuts or

adjustments. Lower blade to 2 inches or closer to

the table top to tilt the saw. Failure to do this may

result in damage to your saw.

LOCKWASHER

INSTALLING HANDWHEELS

Line up FLAT SPOTS on shaft and handwheel, push

handwheel onto shaft. Install screw and Iockwasher

to lock handwheels on shaft.

ELEVATION

HANDWHEEL

10-32 x 3/4 IN.

PHILLIPS

HEAD SCREW

TILT HANDWHEEL

CHECKING TABLE iNSERT

1. Insert should be even with table top. Check as

shown, Loosen flat head screw that holds insert

and adjust the four set screws as necessary.

Tighten flat head screw. Do not tighten screw to

the point where it deflects the insert.

3/32 IN

SETSCREW WRENCH

TABLE INSERT_

2. To remove insert. _-..._1

A. Loosen Phillips Flat Head Screw.

B. Lift insert from front end, and pull toward front

of saw.

3. To replace insert.

Place insert into insert opening in table and push

toward rear of sawto engage spring clip and until

keyslot in insert will drop over screw. Tighten

screw_ . .....

Do not tighten screw to the point where it will

deflect the insert. _-_.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

No comments

Craftsman 113.241680 Owner's Manual Page 10