Craftsman 113.241680 Owner's Manual download pdf (Page 26)

4. if the head is not square with the bar, adjustments

are required,

A. Loosen the "knob" (1) and the "two screws"

(2),

B. Position the HEAD square with the BAR using

a combination square.

C. PUSH the STOP PiN into theslot in the head a t

"0"... push the pin into the slot and twist it.

Lock the knob.

D. Recheck with the square. If the head is still not

square, loosen the screws (2) and readjust the

INDICATOR BLOCK,

E. With the head square with the bar and the pin

pushed into the slot adjust the pointer (3) to

point to "0".

F. The miter gauge head must rest on top of the

bar without being able to move up and down

. . yet it must swivel freely.

G. The swiveling movement of the head can be

adjusted by tightening or loosening the

setscrew (4) . .. using the 1/8 in. setscrew

wrench.

NOTE: The setscrew is located inside of the

head. To reach it, swivel the head to 60

degrees and turn the miter gauge upside

down.

1/8 IN. SETSCREW

WRENCH

PLUGGING IN MOTOR

1. From among the loose parts, find two wire ties.

2. Route motor cord along right side of cabinet and

snap ties in 1/4" hole in side of cabinet. Secure

two cords in wire ties.

3. Plug motor cord into outlet on side of switch box.

WiRE TIES

EXTENSION REMOVED FOR

PICTURE CLARITY

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

No comments

Craftsman 113.241680 Owner's Manual Page 26