Craftsman 113.290650 Operations Instructions download pdf (Page 20)

INSTALLING BELT GUARD SUPPORT

1. Screws furnished with guard are "self

threading".., screw them into holes in BELT

GUARD SUPPORT BRACKET. then remove

them.

2. Position BELT GUARD SUPPORT BRACKET

and BELT GUARD SUPPORT as shown and

install the screws., make sure motor shaft is in

CENTER of hole in SUPPORT.

_ "'7 TWO HOLES CLOSEST

TOGETHER

_"_;'_"_% 10-32 X 1/2 IN.

BELT GUARD

SUPPORT BRACKET - K._J_\%.__..SELF.THREADIN

_ SCREW

BELT GUARD SUPPORT

BELT GUARD

SUPPORT

3. Install three CLIPS (furnished with guard) 90°

apart starting with one clip at the end of the

guard as shown . .. LONG END of clip facing

AWAY from you.

4. Do not assemble belt guard to belt guard

support at this time

BELT GUARD

PIVOT

-CENTERED

OPENING

LONG END

INSTALLING MOTOR PULLEY AND BELT

1, Loosen set screw in motor pulley using 5/32 in,

setscrew wrench. Slide pulley on shaft with HUB

away from motor, DO NOT TIGHTEN

SETSCREW.

2. Install 3/16" n. square key (in loose parts) in

grooves in pulley and motor shaft. DO NOT

TIGHTEN SETSCREW at this time.

KEY

PULLEY SETSCREW

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

No comments

Craftsman 113.290650 Operations Instructions Page 20