Craftsman 113.290650 Operations Instructions download pdf (Page 10)

MOUNTING THE MOTOR

1. From among the loose parts, find the following

hardware:

2 Hex Head Screws 5/16-18 x 5/8 in. long

4 Carriage Bolts, 5/16-18 x 3/4 in. long

4 Hex Nuts. 5/16-18

(approx. dia. of hole 5/16 in.)

4 Lockwashers, 5/16 in. External Type

(approx. dia. of hole 5/16 in.)

2. Place motor on MOTOR BASE... insert bolts

through holes in base., then through the

motor. Install Iockwashers. and nuts.

3. Position motor so that edge of MOTOR FOOT

and MOTOR BASE are even.., slide motor all

the way to the RIGHT.. tighten the four nuts,

LOCKWASHER

5/16 IN.

NUT I

5/16-18 I

THESE TWO CARRIAGE BOLT

EDGES EVEN 5116-18 X 314 IN.

A

./"

BASE

BASE

4. Screw the two 5/16-18 x 5/8 in. motor base

clamp screws part way into tapped holes in

cradle.

5. Lift motor and insert the TWO PINS on motor

base into HOLES in cradle.., push motor in as

far as it will go.

6. Tighten the two motor base clamp screws.

CLAMPSCREWS

5/16-18XS/81N.

HEX. HD. SCREWS

7. Loose_ the two MOTOR CLAMP SCREWS on

each end of motor. Rotate the motor so that the

CAPACITOR COVER is on _op... tighten the

screws. The ventilation holes are now facing

downward which will help prevent sawdust from

entering motor.

CAPACITOR

COVER

VENTILATION

HOLES

MOTOR

CLAMPSCREWS

(BOTH ENDS)

10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Comments to this Manuals

No comments