Craftsman 113.213850 Owner's Manual download pdf (Page 19)

trouble shooting

WARNING: FOR YOUR OWN SAFETY, TURN SWITCH "OFF" AND ALWAYS REMOVE PLUG FROM

POWER SOURCE OUTLET BEFORE TROUBLE SHOOTING.

®CONSULT YOUR LOCAL SEARS SERVICE CENTER IF FOR ANY REASON MOTOR WILL NOT RUN.

TROUBLE PROBABLE CAUSE

1. Incorrect belt tension.

Noisy Operation

Drill Burns.

Drill leads off ...

hole not round.

Wood splinters on

underside.

Workpiece torn

loose from hand.

Drill Binds in

workpiece.

Excessive drill

runout or wobble.

Quill Returns

too slow or too fast.

2. Dry Spindle.

3. Loose spindle pulley.

4. Loose motor pulley.

1. Incorrect speed.

2. Chips not coming out

of hole.

3. Dull Drill.

4. Feeding too slow.

5. Not lubricated.

Hard grain in wood or

lengths of cutting

lips and/or angles

not equal.

1. No "back-up material"

under workpiece.

1. Not supported or

clamped properly.

1. Workpiece pinching drill

or excessive feed pressure.

2. Improper belt tension.

1. Bent drill.

2. Worn spindle bearings.

3. Drill not properly

installed in chuck.

4. Chuck not properly installed.

1. Spring has improper tension.

REMEDY

1. Adjust tension. See section

"ASSEMBLY - TENSIONING BELT."

2. Lubricate spindle. See "Lubrication"

section.

3. Check tightness of retaining nut on

pulley, and tighten if necessary.

4. Tighten setscrews in pulleys.

t. Change speed. See section "Getting

To Know Your Drill Press"...

DRILLING SPEED.

2_ Retract drill frequently to clear chips.

3. Resharpen drill.

4. Feed fast enough.., allow drill to cut.

5. Lubricate drill. See "Basic Drill Press

Operation" section.

1. Resharpen drill correctly.

1. Use "back-up material"... See Basic

Drill Press Operation" section.

1. Support workpiece or clamp it...See

"Basic Drill Press Operation" section.

1. Support workpiece or clamp it... See

"Basic Drill Press Operation" section.

2. Adjust tension.,. See section

"ASSEM BLY - TENSIONING BELT".

1. Use a straight drill.

2. Replace bearings.

3. Install drill properly... See "Basic

Drill Press Operation" section.

4. Install chuck properly.., refer to

"Unpacking and Assembly Instruc-

tions... INSTALLING THE CHUCK".

1. Adjust spring tension... See section

"Adjustments - Quill Return Spring".

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Craftsman 113.213850 Owner's Manual Page 19

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.213850