Craftsman 113.213850 Owner's Manual download pdf (Page 11)

5. Apply tension to belt by turning Belt Tension

Handle counter clockwise until belt has mod-

erate tension on pulleys.

6. Tighten Belt Tension Lock Handles. Belt

should deflect approximately 1/2 inch by

thumb pressure at center of belt.

7. Close belt guard.

8. If belt slips while drilling, readjust belt

tension.

INSTALLING LIGHT BULB

1. Install a Hght bulb (not larger than 60 watt)

into the socket inside the head.

%

\

ADJUSTING THE TABLE SQUARE TO HEAD

NOTE: The combination square must be "true".

See "Unpacking and Checking Contents" section

for method.

t. insert a precision ground steel rod approxi-

mately 3" long into chuck and tighten.

2. With table raised to working height and lock-

ed on column, place combination square flat

on table beside rod.

,

,

,

6.

If an adjustment is necessary, loosen the set

screw under bevel lock with set screw

wrench, then loosen the table bevel lock with

adjustable wrench. [These adjustments are

located under the table].

Align the table square to the rod by tilting

arm until square and rod are in line.

Retighten table bevel lock nut.

Retighten set screw.

11

ARM

TABLE I/_I _ BEVEL

I I k""C_ I LOCK

o t

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments