Craftsman 113.213850 Owner's Manual download pdf (Page 7)

assemb0y

WARNING: FOR YOUR OWN SAFETY, NEVER

CONNECT PLUG TO POWER SOURCE OUTLET

UNTIL ALL ASSEMBLY STEPS ARE COMPLET-

ED.

ASSEMBLY OF COLUMN AND TABLE

HARDWARE

1. Position base on floor. Remove protective

covering and discard.

2. Remove protective sleeve from column tube

and discard. Place column assembly on base,

and align holes in column support with holes

in base.

3. Locate four (4) 318-16Xll/2 bolts and four (4)

3/8 Iockwashers among loose parts bag.

4. Install a Iockwasher and bolt in each hole

through column support and base, and tight-

en with adjustable wrench.

COLUMN I

SUPPORT J

5. Locate table crank assembly, support lock,

and set screw wrench among loose parts.

6. Install table crank assembly and tighten set

screw with wrench provided.

7. Install support lock from left side into table

support and tighten by hand.

.

Handle should turn freely when raising or

lowering table. If adjustment is needed,

loosen jam nut, with a screwdriver loosen

bolt handle until there is play between jam

nut and handle. Tighten jam nut securely

while holding bolt handle with screwdriver.

TABLE

SUPP

SUPPORT

LOCK

TABLE /

SUPPORT /_

I HANDLE

TABLE -..-.-.,-_L._-_ ',' .

C RAN K _/"_'7_f

,

Position column collar over rack and tighten

set screw in collar with wrench provided.

Allow sufficient movement to prevent rack

from binding when moving table to the side.

._ COLUMN

COLUMN _'-_

COLLAR I IT]I (4_Tf "--_

K

INSTALLONG THE TABLE

CO

TABLE

SUPPORT

Loosen support lock and raise table support

by turning table crank clockwise until sup-

port is at a working height level. Tighten sup-

port lock. SUPPORT

LOCK

TABLE

TABLE

CRANK

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments