Craftsman 113.213850 Owner's Manual download pdf (Page 17)

When drilling with the table tilted, ALWAYS

CLAMP WORKPIECE AND BACK-UP MATERIAL

SECURELY TO TABLE before operating Drill

Press.

To return table to original position: !oosen set

screw and bevel lock, tilt table back to 0° on

bevel scale, and retighten set screw - then tight-

en bevel lock.

HOLE LOCATION

Make a DENT in the workpiece where you want

the hole.., using a CENTER PUNCH or a SHARP

NAIL.

Before turning the switch ON, bring the dr

down to the workpiece lining it up with the ho

location.

FEEDING

Putt down on the feed handles with only enough

effort to allow the drill to cut.

Feeding TOO SLOWLY might cause the drill to

burn... Feeding TOO _APIDLY might stop the

motor.., cause the belt or drill to SLIP... tear

the workpiece LOOSE or BREAK the drill bit.

adjustments

WARNING: FOR YOUR OWN SAFETY TURN

SWITCH "OFF" AND REMOVE PLUG FROM

POWER SOURCE OUTLET BEFORE MAKING

ANY ADJUSTMENTS.

QUILL RETURN SPR_NG

NOTCH

BOSS

,

Move the stop nuts and depth pointer to low-

est position and lock in place with wrench to

prevent quill dropping while tensioning

spring.

2. Lower table for additional clearance.

3. Work from left side of Drill Press.

NOTCH

4.

.

.

Place screwdriver in lower front notch of

spring cap, and hold it in place while loosen-

ing and removing jam [outer] nut only.

With screwdriver remaining in notch, loosen

large standard [inner] nut (approximately 118")

until notch disengages from boss on head.

Carefully turn screwdriver counter clockwise

and engage next notch in boss. DO NOT

REMOVE SCREWDRIVER.

JAM NUT

(OUT'ER)

STANDARD

NUT

(INNER)

7. Tighten standard nut with wrench only

enough to engage boss. Do not overtighten

as this will restrict quill movement.

8. Move stop nuts and depth pointer to upper

most position and check tension while turn-

ing feed handles.

g. If there is not enough tension on spring,

repeat steps 4-8 moving only ONE notch each

time and checking tension after EACH repeti-

tion.

10.

11.

Proper tension is achieved when quill returns

gently to full up POSition when released from

3/4" depth.

When there is enough tension after checking,

replace jam nut and tighten to standard nut,

BUT do not overtighten against standard nut.

12.

Check quill while feeding to have smooth and

unrestricted movement. If movement is too

tight, SLIGHTLY loosen jam nut until unre-

stricted.

17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments