Craftsman 315.220381 User Manual download pdf (Page 57)

TROUBLESHOOTING 1

PROBLEM CAUSE SOLUTION

Handwheel is hard to turn or

column binds.

1. Sawdust has collected on the

elevating shaft.

1. Remove handwheel; clean and

lubricate the shaft.

2. Column is out of alignment

2. See Adjus^ng the Column

Tube in Assembly section.

Saw burns or scores edges of

wood in cut.

1. Column tube Is too loose in the

column support.

1. See Adjusting the Column

Tube in Assemb//section.

2. Blade or teeth are bent or dull.

2. Sharpen or replace the blade.

See the removal procedure in

Assembly section.

3. Blade is out of alignment.

3. Use blade alignment proce

dures in Adjustment section.

4. Wrong blade is being used.

4. Change blade. See the removal

procedure in Assemb/y section.

5. Board is warped.

5. Replace the board.

6. Arm is loose or misaligned.

6. See Setting the Arm Lock

Wheel in the Assemb/y section.

7. Yoke is loose on carriage.

7. See Setting the Yoke Clamp

procedure in Assemb/y section.

8. Arm is out of alignment.

8. See Aligning Arm for Cross

Cuts in Adjustments section.

9. Work is being fed too fast.

9. Feed work into blade slower.

Bevel cuts are not true.

1. Bevel lock lever is loose.

1. See SeWng the Bevel Lock

Lever \n Assemb/y section.

2. Blade is not perpendicular to

table top.

2. See Aligning die Blade to the

Table in Adjustments section.

3. Column tube is too loose in the

column support.

3. See AdjusUng the Column

Tube in Assembly section.

4. Table top is not parallel to the

arm.

4. See Leveling Table Supports

and Leveling die Front Table in

the Assemb/y section.

5. Yoke is loose on carriage.

5. See Setting the Yoke Clamp

procedure in Assembly section.

6. Arm is out of alignment.

6. See Aligning Arm for Cross

Cuts in Adjustments section.

57

CRHFfSMmr RADIAL SAW 315.220381

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 81 82

Comments to this Manuals

No comments