Craftsman 315.220381 User Manual download pdf (Page 31)

ASSEMBLY

LEVELING THE TABLE SUPPORTS

See Figures 22A and22B.

The table supports must be perfectly level.

■ Pull the bevel lock lever forward to unlock it. Use

the bevel index knob to rotate the motor so the

arbor shaft points down. Lock the bevel lock lever.

■ Release the arm lock knob to angle the arm. Begin

by positioning the arbor shaft over the back of the

highest table support. Normally this is the left side.

See Figure 22A.

■ Lock the arm lock knob and the carriage lock knob.

■ Using one of the blade wrenches as a feeler gage,

place it on the table support below the arbor shaft.

■ With the elevating handwheel, carefully lower the

motor until the shaft just touches the wrench. The

wrench should move with only slight resistance.

Securely tighten the back screw on the table

support.

■ Without changing the elevation, move the arm to

place the blade arbor over the front of table sup

port, See Figure 22B.

Place the wrench below the shaft and check that

the clearance is the same. If not, adjust the table

support until it is the same. Securely tighten the

front screw.

Move the arm to the opposite side and repeat the

above procedure. When the opposite side is level,

recheck the first side to make sure that it is still

accurate and even.

Return the saw and motor to normal height and

position.

BLADE

WRENCH AT

FRONT

Fig. 22B

ARM LOCK KNOB

BEVEL

INDEX KNOB

BEVEL

LOCK LEVER

BLADE WRENCH

AT BACK

BLADE

ARBOR

LEFTSIDE

TABLE SUPPORT

RIGHT SIDE

TABLE SUPPORT

ELEVATING

HANDWHEEL

Fig. 22A

CMFISNIir RADIAL SAW 315.220381

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 81 82

Comments to this Manuals

No comments

Craftsman 315.220381 User Manual Page 31

Comments to this Manuals

Related products and manuals for Power saws Craftsman 315.220381