Craftsman 315.220381 User Manual download pdf (Page 38)

ADJUSTMENTS

This procedure squares the blade to the table at 0*

bevel (vertical) so the blade angle will be accurate. If

the blade is pot at 0' bevel, follow the steps below to

rotate slightly. You will need a framing square and a

1/4 in. hex key.

■ Position the blade in front of the fence. Lower the

blade with the elevating handwheel until It just

clears the front table.

■ Lock the following controls:

bevel lock lever below the handle,

carriage lock knob on the left side,

arm lock knob on top of the arm, and

yoke lock handle below the yoke, on the right,

fl Stand a framing square on the table with the short

leg pointing up against the saw blade and the long

leg parallel to the fence. Place the square flat

against the blade between two teeth.

B If both the top and bottom of the saw blade are flat

against the square, no adjustment Is needed.

B If the saw blade gaps at the top or bottom, remove

the bevel index cap by removing the two philllps

head screws (below the handle). You will see four

socket head screws.

B Loosen the socket head screws with a 1/4 in. hex

key. Rotate the motor slightly while holding the

square against the saw blade and table top.

B Slightly tighten each of the four screws and recheck

the blade and framing square.

ARM LOCK KNOB

ALIGNING BLADE TO TABLE AT 0‘ BEVEL

See Figures 30A - 300.

If there are no gaps, fully tighten each screw. If

there is still a gap, repeat the previous two steps.

Check the bevel Indicator on the yoke assembly

near the handle. It should read 0*. If it does not,

reset it by loosening the screws and rotating the

bevel index cap. Retighten the two screws.

Loosen the carriage lock knob.

BLADE SQUARE TO TABLE

NO ADJUSTMENT NEEDED

FRAMING

SQUARE

TABLE

FRONT TABLE

ELEVATING

HANDWHEEL

Fig. SOD

CRRFTSMflN* RADIAL SAW 315.220381

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 81 82

Comments to this Manuals

No comments

Craftsman 315.220381 User Manual Page 38

Comments to this Manuals

Related products and manuals for Power saws Craftsman 315.220381