Craftsman 315.220381 User Manual download pdf (Page 55)

1 TROUBLESHOOTING

PROBLEM

CAUSE

SOLUTION

Saw does not start.

1. Motor cord or control-cut cord is

not plugged in.

1. Plug in cord.

2. Cord or switch is damaged.

2. Have the cord or switch re

placed at your nearest Sears

Service Center.

3. Circuit fuse is blown.

3. Replace circuit fuse.

4. Circuit breaker is tripped.

4. Reset circuit breaker.

5. Switch is burned out.

5. Have the switch replaced and

request a voltage check from

the power company.

6. Connections are loose, burned

out, or damaged.

6. Have the wiring checked and

repaired. Request voltage check

from power company.

Motor does not reach full speed or

power.

1. Voltage from source,is low.

1. Request a voltage check from

the power company.

2. Circuit is overloaded with other

appliances or motors.

2. Test without any other motors

and on different circuit.

3. Motor windings are burned out.

3. Have the windings replaced and

request a voltage check from

the power company.

4. Fuses or circuit breakers are

wrong size.

4. Have an electrician replace with

a 15 amp fuse or circuit breaker.

5. Extension cord is too long.

5. Use a shorter cord.

6. Starter switch is defective.

6. Have the switch replaced.

Motor stalls, blows fuses, or trips

circuit breakers.

1. Starter switch is defective.

2. Voltage from source is low.

1. Have the switch replaced.

2. Request a voltage check from

the power company.

3. Fuses or circuit breakers are

wrong size or defective.

3. Have an electrician replace with

a 15 amp fuse or circuit breaker.

Motor overheats.

1. Motor is overloaded.

1. Request a voltage check from

the power company.

2. Windings are burned out.

2. Have the windings replaced and

request a voltage check from

the power company.

3. Work is being fed too fast.

3. Feed work slower.

55

CRRFTXMRN* RADIAL SAW 315.220381

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 81 82

Comments to this Manuals

No comments