Craftsman 351.217570 Operator's Manual download pdf (Page 3)

Refer to Figure 1.

Check for shipping damage. If damage has occurred, a claim

must be filled with carrier. Check for completeness.

Immediately report missing parts to dealer.

The sander comes assembled as one unit. Additional parts

which need to be fastened to sander, should be located and

accounted for before assembling.

A Sander

B Dust Collection Bag

C Bag Clamp

D Miter Gauge Assembly

E Support Rod

F Table Assembly

Hardware Bag (Not Shown)

............

Figure 1 - Unpacking Sander

Refer to Figures 2 - 6.

CAUTION: Do not attempt assembly if parts are missing.

Use this manual to order replacement parts.

WARNING: Do not operate machine until completely assem-

bled. Do not operate machine until you have completely read

and understood this manual.

TOOLS NEEDED

While assembling or adjusting your belt and disc sander, you

will need the following tools:

• 10ram Wrench

• 5 and 6mm Hex Wrenches

• Combination Square

• Phillips Screwdriver

MOUNT SANDER

Refer to Figure 2.

NOTE: Although compact, the sander is heaw. At least two

people are required to lift from carton.

Choose a suitable location to mount the sander. The sander

must be installed in a place with ample lighting and correct

power supply. To install sander:

• The sander must be bolted to a firm, level surface.

• Make sure there is plenty of room for moving the work-

piece. There must be enough room that neither operators

nor bystanders will have to stand in line with the wood

while using the tool. Allow room so that belt assembly can

be positioned horizontally.

° Sander can be installed on a workbench or a tool stand

(see Recommended Accessories, page 15) using bolts,

lock washers and hex nuts (not supplied).

° Figure 2 shows the base dimensions, mounting holes and

required space to allow for table assembly and belt

assembly in horizontal position.

3/8"Dia,

17%"

"_ ] 2" _

),, 30"

=_ 21" =,

Figure 2 - Base Dimension and Required Space

ATTACH TABLE ASSEMBLY

Refer to Figures 3 and 4, page 4.

The included table assembly is used with both the disc and

belt.

To use the table with the disc:

• Insert table support rod into sander base. Secure using bolt

(A), make sure bolt tightens onto the flat surface of the rod.

• Position table assembly on support rod so that gap

between table and disc is 1/1J'or less. Secure table in

position with bolt (B).

Bolt (B)

Figure 3 - Using Table with Disc

1 2 3 4 5 6 7 8 ... 27 28

Comments to this Manuals

No comments

Craftsman 351.217570 Operator's Manual Page 3

Comments to this Manuals

Related products and manuals for Power tools Craftsman 351.217570