Craftsman 351.217570 Operator's Manual download pdf (Page 7)

Tracking Nut

Tension Lever

Figure 10 - Adjusting Belt Tracking

ADJUSTING BELT ASSEMBLY POSITION

Refer to Figure 11.

Sanding belt assembly can be adjusted from vertical to

horizontal position, or any angle in between.

• Loosen socket head bolt that is threaded into pivot bracket.

• Tilt belt assembly to desired position. Secure belt assembly

position by tightening socket head bolt in pivot bracket.

• Adjustable positive stops are provided for both horizontal

and vertical positions.

NOTE: The horizontal stop is located on top of the base.

Horizontal

Stop

Pivot

Figure 11 - Belt Assembly Adjustments

ADJUSTING TABLE ANGLE

Refer to Figure 12.

° To adjust table angle, loosen knob, tilt table to desired

position, then secure by tightening knob.

° Reposition table on support rod to ensure that gap between

table and belt (disc) is '/_" or less. To reposition table,

loosen bolt, move table on rod and secure in position by

tightening bolt.

Loosen to Change

Figure 12 - Reposition Table when Tilting the Table

HORIZONTAL BELT SANDING WITH WORK STOP

Refer to Figure 13.

° Remove table assembly and support rod from belt

assembly.

° Tilt belt assembly from vertical to horizontal position and

secure in position.

° The work stop has been integrated into the dust shroud.

° Idler drum can be used as a contact drum to sand surfaces.

Dust Shroud

Stop

Figure 13 - Using the Work Stop

ABRASIVE BELT SANDING

° Finishing flat surfaces: Hold workpiece firmly with both

hands; keep fingers away from abrasive belt.

Use table to position and secure work being sanded. Keep

end butted against table and move work evenly across

abrasive belt.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Craftsman 351.217570 Operator's Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Craftsman 351.217570