Craftsman 113.29461 Owner's Manual download pdf (Page 9)

MITER

SCALE

ATTACHING

SCREWS 0 o

MARK

Figure 21

Figure 22

MITER

SCALE

it'q[

MITER SCALE

INDICATOR

Figure 23

g. Now slowly move the carriage outward along the

radial arm. The tooth you have marked should just

touch the long leg of the square at all points. If it

does not, make the following adjustments:

(1) If your marked tooth moves into the square as

the carriage is moved outward, tap the left-front

edge of the table with a rubber mallet until you

can perform step "g" correctly.

(2) If the tooth movesawav from the square, tap the

right-front table edge to make the correction

(3) Recheck until you can perform step "'g" correct-

ly, then securely tighten all six of the front table

hold-down screws. Also refer to page 20, steps

'q" and "j" of Trouble Shooting Section.

h. Loosen the two miter-scale attaching screws and

rotate the scale to align its 0 ° mark with the

miter-scale indicator. Tighten the screws.

NOTE: This squaring of the crosscut travel will

simultaneously set both of the 45 ° index

positions of the radial arm.

5. Installing the Remaining Table Boards (Figure 24)

a. Position the rip fence, spacer board and rear table

board behind the front table board, as shown.

b. Install the two table clamps in the slots provided for

them at the rear of the saw base, and tighten them

securely.

NOTE: The life of your saw table will be

lengthened considerably if you will cover the

front table with a fitted piece of 1/4-inch

plywood. This should be tacked in place for

easy replacement. Use of such a cover will

allow, you to do all cutting into the cover,

rathe_ than your table top.

6. Setting the Bevel-Index Indicator (Figure 25)

a The bevel index indicator should read 0 ° on the

TABLE CLAMP

FRONTTABLE

REAR TABLE

SPACER

RIP FENCE

Figure 24

__ Figure 25

_'_ k _ BEVEL INDEX

[ 0 OS,T,ON

\ tL )))Y7"----BEVEL'N°'cAT°R

BEVEL LOCK KNOB

bevel-index scale when the motor is locked (bevel

lock knob tightened) into position with the saw

blade vertical.

b. If necessary, loosen the indicator attaching screw,

adjust the indicator to theO °reading,then retighten

the attaching screw.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments

Craftsman 113.29461 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.29461