Craftsman 113.29461 Owner's Manual download pdf (Page 7)

U-CLIP

BASECROSS-MEMBER Figure

k. Adjust the right-hand table support in exactly the

same manner, without altering the radial-arm eleva-

tion setting.

Loosen the bevel lock knob and, while holding the

bevel latch-pin handle up, rotate the motor to a

horizontal position - then release the latch-pin

handle so that the pin bottoms in its detent, and

tighten the lock knob.

m. Move the radial arm to 0 ° (center) position and lock

it by tightening the arm-latch handle.

3. Installing the Front Table (Figures 11 through 15)

P_ace the front table (largest) board upside down on

a workbench or the floor. It is upside down when the

face in which the screw holes are counterbored is at

bottom. Note that there are two holes near the

center of the board, one smaller in diameter than the

other. Drive the T-nut (furnished with loose parts)

into the smaller of these two center holes.

Turn the front table top side up and place it on the

table supports, locating it so that the six screw holes

near the board sides are aligned with their corre-

sponding holes in the two supports.

C. In each of the six boles located above the table

supports, place one 17/64-inch flat washer and one

1i4-20xl-inch pan-head machine screw. In the larger

of the two center holes place one 17!64-inch flat

washer and one 1/4-20xl 1!4-inch pan-head machine

screw - and start the screw into the U-nut on the

front of the saw base (but do not tighten it). In the

smaller center hole {with the T-nut underneath),

barely start the cup-point set-screw.

Install one 1!4-inch Iockwasher and one 1/4 20 hex

nut on each of the six screws in the table supports,

and tighten slightly. The board should be snug

against the supports, but not held too tightly to be

moved by tapping it firmly with a rubber mallet.

Figure 12

A CROSS_SECTIONA L

VIEW THROUGH

CENTER OF T-NUT

1t4 20x 1" PAN-HD. SCREW

F F 17/64" FLAT WASHER

FRONT _ _, [----;/4t_i2Cx ,1 1/4"' PAN lid

TABLE [/ "_i v, , I

1/4-LOCK °

1/4-20 I ,__

HEX NUT _ _" Figure 73

NOTE: Setscrew is shown as it will

be when tightened. For step 3c it

must not touch the saw base.

CUP-POI NT SETSCREW_

Figure 14 FRONTTABLE_______

REAR TABLE BOAR

Figure 15

FRONT TABLE

e. Move the carriage to its extreme rear position, and

tighten the carriage lock knob.

f. Lay the rear table board on edge across the front

table to serve as a straightedge. Sight under this

straightedge to determine whether the front table

board is high or low at its center.

g. If the front table is high at center, first tighten the

center (1/4-20x1-1/4-inch) hold-down screw until the

table is level - then tighten the leveling screw until

this screw is snug If table is low at center, hrst

tighten the leveling screw until the table is level -

then tighten the hold down screw.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Craftsman 113.29461 Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.29461