Craftsman 113.29461 Owner's Manual download pdf (Page 4)

unpacking and preassembly

2. Mounting Your Saw on a Workbench

Mount on a Craftsman Power Tool Base or a sturdy, flat

bench, in such a position that the elevation crank will be

free to rotate,

WARNING: Do not connect the power cord to

a source of power. This cord must remain un-

plugged whenever you are working on the saw.

3. Installing the Elevation Crank and Swivel Latch-Pin

Knob (Figure 2)

a. Install the elevation crank and tighten the setscrew

on the flat portion of the shaft.

Figure 2 ,_

SWIVEL LATCH-PIf CARRIAGE

KNOB -- STOP

SCREW

SHIPPING

BLOCK

CARRIAGE

ASSEMBLY

ELEVATION C

Figure 3

4. Installing the Motor and Carriage Assembly on the

Radial Arm (Figures 2 and 3)

a. Rotate tbe elevation crank clockwise several turns

and remove the shipping block from between the

carriage and the radial arrn.

b. Remove the carriage stop screw. Iockwasher and

warning tag.

c. Holding the carriage assembly with both hands,

carefully start and slide the carriage onto the

radial-arm tracks. The assembly must be held parallel

with the arm so that all four of the assembly bearings

will smoothly slide onto the two arm tracks, thus

preventing any excessive strain on the bearings and

tracks.

d. Reinstall the carriage stop screw and Iockwasher.

WARNING: Unless this is done carriage can rol!

off the arm.

e. Remove the two shipping screws from bottom of

motor, and discard. Leaving these in would limit

depth of cut.

f. Check the cord in the arm cord clip to make sure

there is 30 inches length of cord between this clip and

the cord clip on the yoke.

g. Install the swivel latch pin knob.

ARM CORE) CLIP

View above

shows R-H

indicator

installed.

Figure 4

5. Installing the Rip Scale Indicators (Figure 4)

a. Remove the carriage lock knob, then remove the

right-hand carriage cover.

Attach a rip-scale indicator to the top of the carriage

cover, using one twin nut and two 6 32x7/16-inch

pan-head screws. Tighten the screws lightly -- the

indicator will be adjusted, later

c, Reinstall the carriage cover and knob.

Similarly attach the remaining rip-scale indicator to

left-hand carriage cover, then reinstall this cover

Note that there is no knob on the left side; only [he

cever need be removed and reinstalled.

1 2 3 4 5 6 7 8 9 ... 35 36

Comments to this Manuals

No comments

Craftsman 113.29461 Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.29461