Craftsman 113.29461 Owner's Manual download pdf (Page 22)

F,gu,o,8!

SOCKET HD

SCREW

(4 Tolal)

_ BEVEL

INDEX

SCALE

)) BEVEL

INDICATOR

LOCK KNOB

(b) Using a 1/4-inch hex-L wrench, slightly

loosen the four socket-head screws (figure

48L

with the table top as shown in figure 47.

Then, while holding the square firmly

against the saw blade and table top, apply

moderate force against the lower part of the

saw blade with your thumb, until approxi-

mately 1/32 inch clearance exists between

the square and the lower edge of the blade.

This is to compensate for the possible slight

shifting of the motor while the socket-head

screws are being tightened.

(d) Tighten the four socket-head screws and

replace the bevel lock knob (figure 48). It

may be necessary to perform several trial

operations before the saw blade remains

perfectly square with the table, after tighten

ing the four screws.

(4) After completing this adjustment, set the bevel

indicator to zero.

k, Adjusting Carriage Bearings (Figs. 49 through 52).

To test for looseness between the carriage bearings

and the tracks on the radial arm, lock the yoke-clamp

handle (figure 49), grasp the motor and carriage

assembly firmly with both hands, and apply a firm

rocking motion. If looseness exists, perform the

following steps :

NOTE: Adjustment is made on lefr-hand side, onlyo

(1) Remove left-hand carriage cover (figure 50).

(2) Loosen the two nuts (figure 51) just enough to

permit the two eccentric screws to turn. (See

figure 52.)

(3) Rotate one of the eccentric screws a partial turn

(left or right) as required to take up looseness,

Hold the head of the eccentric screw (figure 51)

m the position established by this method and

t_ghten the nut. Repeat this procedure for the

other eccentric screw. Correct adjustment exists

.vhen there is no play between the carriage and

the radial arm tracks, but the carriage moves

',0ack and forth freely.

(4) Reinstall the left-hand carriage cover (figure 50).

YOKE CLAMP

HANDLE

MOTOR AND CARRIAGE

ASSEMBLY

Fiqure 49

LEET_HD,

CARRIAGE

COVER

ATTACHING

SCREW

(2 Total)

Figure 50

._r_ .,_,.._ E c CENT R I C SCREW

k II II d_'_-,_--_CAR RIAGE

BEARING

PLAIN WASHER"_k--_I IIk\\"l_'_"{'_:'k-_

R'AOE

LOCKWASH E R t"t_w__ NUT

Figure 52

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Comments to this Manuals

No comments

Craftsman 113.29461 Owner's Manual Page 22

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.29461