Craftsman 351.217881 Operations Instructions download pdf (Page 4)

Fence Tilting _

Handle _.

Fence Bracket

Figure 3 - Attach Fence Assembly

• Make sure limit plate (Figure 4, page 4) is resting in

slot of block. Position fence against shaft and lock

fence in position with fence tilting handle.

• Place a combination square against face of fence

and table surface. The fence and table must be at

90° to each other. If not, loosen tilting handle, loosen

hex nut and turn shaft with a screw driver until fence

is square. Secure in position by tightening hex nut.

• Use a bevel gauge or protractor to check 45° inward

and outward limit stops. The 45° inward stop is the

hex head bolt located beneath the shaft. The 45 °

outward stop is located at the top of the fence. If

adjustment is needed, loosen hex nut, turn hex head

bolt to proper position and secure in place with hex

nut.

Block

Limit Plate__ Hex Nut

45° Stop

Figure 4 - Limit Stops

INSTALL DUST CHUTE

Refer to Figure 25, page 16.

• Insert pan head screw (Key No. 19) through tabs on

dust chute (Key No. 18). Slide dust chute onto end of

chip exhaust (Key No. 17). Tighten pan head screw.

INSTALLING THE HALF BAG DUST

COLLECTION SET

Refer to Figure 5.

The Craftsman Half Bag Dust Collection Set is

designed to provide dust collection for woodworking

tools with a 21/2"diameter dust exhaust port. The filter

bag attachs to a 30-gallon trash can or a 30-gallon x

1.3 mil plastic trash bag for easy, convenient sawdust

disposal (trash can and plastic trash bag not included).

To use dust collection set with a trash can:

• Place spring inside filter bag arm.

• Slide arm with spring over dust exhaust port.

• Place band of the bag over rim of trash can and

secure bag by tightening strap.

To use dust collection set with a trash bag:

• Place spring inside filter bag arm.

• Slide arm with spring over dust exhaust port.

• Assemble bag support. Slide connectors into

channels of support segments.

• Slide plastic trash bag inside and over bag support.

Let bag overlap 3-4".

• Place band of the filter bag over and into the

channel of the bag support.

• Secure in position by tightening strap.

Spring

_.4__ Dust Exhaust Port

_. _ _ _'_:_' Support

i--tlter_ag _..._ Segments

_, f / Connector /

k - J Bag

_/Support

/I_ _Strap /_

Baod

Figure 5 - Half Bag Dust Collection Set

Refer to Figure 6-10, pages 4-6.

The jointer/planer weighs approximately 70 Ibs. when

completely assembled. The jointer/planer must be

installed in a place with ample lighting and correct

power supply. To install jointer/planter:

• Make sure there is plenty of room for moving the

workpiece through the entire cut. There must be

enough room that neither the operators nor the

bystanders will have to stand in line with the wood

while using the tool.

• Jointer/planer can be installed on a workbench using

mounting brackets provided and bolts, lock washers

and hex nuts (not supplied). See Figure 6.

Jointer Base

Mounting Bracket

Figure 6 - Use Mounting Brackets to Secure Jointer

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Craftsman 351.217881 Operations Instructions Page 4

Comments to this Manuals

Related products and manuals for Power tools Craftsman 351.217881