Craftsman 351.217881 Operations Instructions download pdf (Page 3)

• Avoid accidental start-up. Make sure that the switch

is in the OFF position before plugging in.

• Do not force tool. It will work most efficiently at the

rate for which it was designed.

• Keep hands away from moving parts and cutting

surfaces.

• Never leave tool running unattended. Turn the power

off and do not leave tool until it comes to a complete

stop.

• Do not overreach. Keep proper footing and balance.

• Never stand on tool. Serious injury could occur if tool is

tipped or if blade is unintentionally contacted.

• Know your tool. Learn the tool's operation, applica-

tion and specific limitations.

• Use recommended accessories (refer to page 17).

Use of improper accessories may cause risk of

injury to persons.

• Handle workpiece correctly. Protect hands from pos-

sible injury.

• Turn machine off if it jams. Blade jams when it digs

too deeply into workpiece. (Motor force keeps it

stuck in the work.)

• Always keep drive, cutterhead and blade guards in

place and in proper operating condition.

• Feed work into blade or cutter against direction of

rotation.

CAUTION: Think safety! Safety is a combination of

operator common sense and alertness at all times

when tool is being used.

WARNING: Do not attempt to operate tool until it is

completely assembled according to the instructions.

Figure 1 - Unpacking

Refer to Figures 2, 3, 4 and 24.

ATTACH SUPPORT TO JOINTER

• Attach fence support to jointer with socket head bolts

and lock washers.

• Insert locking plate assembly into support. Position

plate so that pins are against bottom edge of sup-

port.

• Secure plate in position with fence sliding handle and

spacer.

Fence Sliding Handle_ _;_

Fence

Support

Spacer _" "_ /

Refer to Figure 1.

Check for shipping damage. If damage has occurred, a

claim must be filed with carrier. Check for complete-

ness. Immediately report missing parts to dealer.

The jointer/planer is shipped complete in one carton.

Additional parts which need to be fastened to

jointer/planer should be located and accounted for

before assembling.

A Jointer Bed Assembly

B Fence

C Fence Support

D Fence Bracket Assembly

E Locking Plate Assembly

F Fence Sliding Handle with Spacer

G Push Blocks (2)

H Fence Tilting Handle with Spacer

I Dust Chute

Hardware bag includes:

• 8-1.25 x 20mm Socket Head Bolts (4)

• 8-1.25 x 16mm Socket Head Bolts (2)

• 8mm Lock Washer (6)

• 3, 4, 5 and 6mm HexWrench

• Mounting Bracket (4)

L_ocking Plate

Assembly

Figure 2 - Attach Fence Support

INSTALL FENCE AND FENCE BRACKET TO

JOINTER

• Attach fence to fence bracket assembly with four

socket head bolts and lock washers.

• Slide fence and bracket over and onto dovetails of

support and locking plate.

• Continue to slide fence forward so that the fence is

over the jointer tables. At this position the edge of

the blade guard will rest against the fence, and the

entire width of the cutterhead is covered. Secure

bracket in position with fence sliding handle.

• Insert fence tilting handle with spacer through right

link and thread into left link.

1 2 3 4 5 6 7 8 ... 31 32

Comments to this Manuals

No comments

Craftsman 351.217881 Operations Instructions Page 3

Comments to this Manuals

Related products and manuals for Power tools Craftsman 351.217881