Craftsman 320.27683 Operator's Manual download pdf (Page 36)

Fixed Base Router

When using either the fixed base to attach the

router to the router table, the bit depth can

be adjusted by turning the Micro-adjustment

Dial clockwise or counterclockwise with the

wrench supplied. (Fig. 28a and Fig. 28b). The

depth of the cut can be read on the scale dial.

Each mark on the scale indicates a 1/64-in.

change in depth setting.

1. Turn off the router.

Fig. 28a

Loosen the router motor clamp.

Insert the wrench into the adjusting hole

on the tabletop. Turn the adjustment bolt

on the router clockwise with the wrench to

move the collet/nut up, or counterclockwise

to move the collet/nut down.

When the desired depth of cut is set,

tighten the router motor clamp. The

precise depth of cut can be measured with

a ruler.

Fig. 28b

Plunge Base Router

When using the plunge base to attach the

router to the router table, the bit depth can be adjusted by turning the depth rod

clockwise or counterclockwise with the wrench supplied (Fig. 28b).

1. Turn off the router.

2. Loosen the router motor clamp.

3. Lock the plunge-depth locking lever.

4. Insert the wrench into the adjusting hole on the tabletop. Turn the depth

rod on the router clockwise with the wrench to move the collet/nut up, or

counterclockwise to move the collet/nut down

5. When the desired depth of cut is set, tighten the router motor clamp. The

precise depth of cut can be measured with a ruler

27683 ManuaLRevised_11-0120 Page 36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 51 52

No comments

Craftsman 320.27683 Operator's Manual Page 36