Craftsman 320.27683 Operator's Manual download pdf (Page 18)

CUTTER BITS

Get faster, more accurate cutting results by keeping cutter bits clean and sharp.

Remove all accumulated pitch and gum from cutter bits after each use.

When sharpening cutter bits, sharpen only the inside of the cutting edge. Never

grind the outside diameter. Be sure, when sharpening the end of a cutter bit, to

grind the clearance angle the same as was originally ground.

INSTALLING THE ROUTER MOTOR IN THE BASES

_1_ WARNING: Never use the router motor without installing it into either an

approved fixed or plunge base. Failure to do so could result in serious personal

injury and damage to motor.

NOTE: Before installing the motor housing in the fixed base, have the collet/nut

and router cutter bit you are going to use already installed in motor housing. See

"INSTALLING AND REMOVING THE CUTTER BIT".

A_, WARNING: Always turn the motor off and unplug the router from the power

source before making any adjustments or installing accessories. Failure to turn

the motor off and unplug the router could result in accidental starting, which can

cause serious personal injury.

To Install Motor in Fixed Base (Fig. 4)

1. Turn router motor off and unplug

from power source.

2. Place fixed base on flat surface.

With back of fixed base facing you,

open the motor clamp (A).

Press in Coarse Adjustment Knob

(B) while you align the motor slot

base.

When the motor slot is aligned

and engaged into the base's pin,

slide the motor down into the fixed

base.

6. The router motor will now slide up

or down to set coarse adjustments

when the coarse adjustment knob is pressed in.

7. After all adjustments are made, close the router clamp securely.

To Install Motor in Plunge Base (Fig. 5)

1. Turn the motor off and unplug the router from the power source.

2. Place the plunge base on a flat surface.

3. With the back of the plunge base facing you, open the motor clamp (A) and

make sure that the plunge action is in the "UP" position with the plunge lock

lever (B) locked.

27683 ManuaLRevised_11-0120 Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

No comments

Craftsman 320.27683 Operator's Manual Page 18