Craftsman 113.213213 Owner's Manual download pdf (Page 15)

5. Locate idler pulley assembly in loose parts bag and j _y

place in proper hole.

IDLER PULLEY ASSEMBLY

SPINDLE PULLEY

6. Locate two (2) V-belts in the loose parts bag.

7. Use speed chart inside belt guard to choose speed

for drilling operation. Install belts in correct position

for desired speed. The longer of the two belts is

always positioned between the spindle pulley and

idler pulley.

NOTE: Refer to chart inside belt guard for

Recommended Drilling Speeds.

8. Apply tension to belt by turning Belt Tension Handle

counter clockwise until belt deflects approximately

1/2 inch by thumb pressure at its center.

9. Tighten Belt Tension Lock Handles.

NOTE: Over tensioning belt may cause motor not to

start or damage bearings.

10. If belt slips while drilling, readjust belt ten sion.

IDLER PULLEY

BELT

TENSION

(} LOCK HANDLE

BELT GUARD KNOB

SCREW

INSTALLING BELT GUARD KNOB

1. To attach belt guard knob, locate knob and 5mm Dia.

x 12mm long pan hd. screw in loose parts bag.

Install screw _n hole located in guard and attach

knob turning until tight.

BELT

TENSION

HANDLE I

BELT GUARD KNOB _"_J I

WARNING: To avoid possible injury keep guard

in place and in proper working order while

operating.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

No comments

Craftsman 113.213213 Owner's Manual Page 15