Craftsman 113.213213 Owner's Manual download pdf (Page 10)

assembUy

WARNING: For your own safety, never connect

[ plug to power source outlet until all assembly

_ steps are completed.

- TOOLS NEEDED

MEDIUM

SCREWDRIVER

COMBINATION

SQUARE

8-INCH ADJUSTABLE

WRENCH

COMBINATION SQUARE MUST BE TRUE.

Check its accuracy as illustrated below.

DRAW LIGHT

LiNE OH BOARD

ALONG

STRAIGHT EDGE OF

BOARD 3/4" THICK-

THIS EDGE MUST BE

PERFECTLY STRAIGHT

SHOULD BE OVERLAP WHEN

SQUARE IF FLAPPED OVER IN DOTTED POSITION

I WARNING: To avoid back injury, get help to lift the

base, table, or drill press head from the carton.

ASSEMBLY OF BASE/COLUMN

1. Positionbase on floor.

2_ Remove protective sleeve from column tube and dis-

card. Place column assembly on base, and align

holes in column support with holes in base.

3. Locate four (4) 12mm Dia. x 40mm long bolts among

loose parts bag.

4. Install a bolt in each hole through column support

and base and tighten with adjustable wrench.

COLUMN

SUPPORT

12rnm DIA:X 40turn LONG BOLT

ASSEMBLY OF ELEVATION WORM GEAR AND TABLE CRANK

1. Find elevation worm gear shaft, the crank handle

and table crank in the loose parts bag. Insert the ele-

vation shaft into the table support and extend the

shaft through the opening as far as possible. The

crank is to be installed on the elevation worm gear

shaft, the set screw is to be aligned with the fiat por-

tion of the shaft. The crank is to be positioned as

close to the arm support as possible, then tighten set

screw with a 3mm HEX "L" wrench. See illustration.

2. Screw the crank handle intothe table crank as illus-

trated. Use an adjustable wrench to tighten the crank

handle securely.

._ ELEVATION WORM

GEAR SHAFT

TABLE

TABLE SUPPORT

ASSEMBLY

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments

Craftsman 113.213213 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.213213