Craftsman 113.213213 Owner's Manual download pdf (Page 14)

MOUNTING MOTOR

1. Locate four (4) 8mm Dia. x 20mm long hex head y

bolts, eight (8) flat washers, and four (4) hex nuts

among loose parts.

2. Put a fiat washer on each bolt.

3. Install hex head bolts through motor bracket on

head.

4. Place motor in position so motor base slots line up

with motor bracket slots. Install fiat washers and hex

nuts as illustrated. (Do not tighten)

5. Motor shaft should be as close as possible to center

of round opening in belt guard.

8mm Dia.x2_m LONGBOLT

HEXNUT

FLAT WASHER

BOLT

INSTALLING MOTOR PULLEY

1. Find the motor pulley in loose parts bag.

2. Slide pulley onto motor shaft. Line up the flat surface

on the motor shaft with the set screw in pulley.

3. Make sure the pulley does not rest on the lower

guard.

4. Tighten the set screw using a "4" mm Hex "L"

wrench.

MOTOR

BRACKET

MOTOR

BASE

FLAT HEX

WASHER NUT

MOTOR

PULLEY

SET SCREW

FLAT

_ SURFACE

INSTALUNG AND TENSIONING BELT

WARNING: To avoid injury due to accidental

starting always turn drill press off and remove

switch key before making belt adjustments.

1. Place a straight edge such as a piece of wood,

metal, or framing square across the top of pulleys.

2. Move the motor upward until the pulleys are in line.

"13ghtenthe motor mount nuts using an adjustable

wrench.

NOTE: To avoid rattles or other noise, motor frame

must not touch lower belt guard.

3. Release Belt Tension Lock handles located on each

side of Drill Press head by turning them counter-

clockwise.

4. LoosenBelt Tension handle by turningclockwise.

STRAIGHT EDGE

t, 2

0001

LOWER BELT MOTOR

BELT TENSION MOUNT MQTQR

GUARD LOCK NUTS

HANDLE

• '_' BELT

]"__i TENSION

HANDLE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments

Craftsman 113.213213 Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.213213