OPERATION
NON.THROUGH CUTS
See Figure 49.
A WARNING: Unplug the saw while removing or
replacing the blade guard. Turn on the saw with
the switch on the arm to confirm the blade is not
receiving power.
■ Remove the blade and blade guard (see Assembly
section).
■ Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel.
■ Make sure the wood is not touching the blade.
Insert the key and turn on the saw. Let the blade
build up to full spewed before contacting the work
piece.
A WARNING: Always use pushblocks when
** making non-through rip cuts to avoid the risk of
serious injury. Never feed wood with your hands.
■ When the work is completed, press the switch off
and remove the key.
NON-THROUGHCUT
Fig. 49
Control Cut Settings
Wood
Type
Crosscut
Setting
Position
Feet
Minute
Hard
A 0-6
Medium
B 0-20
Soft c
0-35
Wood
Type
iwel Crosse
Setting
Position
ut
Feet
Minute
All Types A 0-6
Wood
Setting
Feet
Type
Position
Minute
Hard
A 0-6
B 0-20
1 Soft 1
c
0-35
1 compound Crosscut 1
Wood Setting
Feet
Type
Position
Minute
All Types A
0-6
S3
CRHPTSMIir RADIAL SAW 315.220381
Comments to this Manuals