Craftsman 358.795020 Operator's Manual download pdf (Page 6)

NOTE:Theendofthetubehasa

groove,orindention,thatalignswitha

ridge,orraisedarea,intheslotinthe

engine.Locatethegrooveandridge.

• Alignthegrooveinthetubewiththe

ridgeinsideopeningintheengine.

Insertthetubeintotheopening.

" _ Ridge _ Groove

• Firmly push the tube into the engine

until it will no longer go into opening.

• Now tighten the screws, using one of

the hex wrenches provided with unit.

ATTACHING THE HANDLEBAR

NOTE: Unlike a bicycle, the handgrips

on the handlebar point toward the front

instead of toward the back.

• Locate decal on handlebar. Align han-

dlebar so inner arrows point to engine.

Make sure the wire assembly is not

wrapped around the tube.

• Set handlebar on mounting bracket.

Align mounting bracket between the

outer arrows on the handlebar decal.

• Position bracket cover over the han-

dlebar. Again make sure the bracket

is between the arrows.

• Insert screws and tighten securely.

• Insert wire assembly into the groove

in the bottom of the foam grip.

Bracket Cover Screw

Foam Grip Handlebar

Mounting

Bracket

Wire Assembly

CONFIGURING YOUR UNIT

You can configure your unit using a

cutting head or weed blade for grass

and light weeds, or a brush blade for

cutting saplings and similar size mate-

rial. Go to the section for the desired

configuration and follow the instruc-

tions for assembling your unit.

TRIMMER

HEAD

WEED

BLADE

O

BRUSH

BLADE

ASSEMBLY FOR USE WITH A

TRIMMER HEAD

TRIMMER

HEAD

NOTE: If your unit has been assembled

for brushblade use, refer to the section

"ASSEMBLY INFORMATION FOR USING

YOUR UNIT WITH A BRUSHBLADE" and

reverse the steps to remove the metal

shield and blade before you mount the

plastic shield and trimmer head.

ATTACHING THE PLASTIC SHIELD

AND TRIMMER HEAD

WARNING: The shield must be prop-

erly installed. The shield provides par-

tial protection from the risk of thrown

objects to the operator and others and

is equipped with a line limiter which

cuts excess line to the proper length.

The line limiter (on underside of shield)

is sharp and can cut you.

• Remove wing nut from shield.

• Insert bracket into slot on shield.

• Pivot shield until bolt passes through

hole in bracket.

• Tighten the wing nut securely.

6

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments