Craftsman 358.795020 Operator's Manual download pdf (Page 5)

CARTONCONTENTS

Checkcartoncontentsagainstthefol-

lowinglist.

Model: 358.795020

• Engine

• 2 tube mounting screws

• 2 tube mounting nuts

• 2 handlebar screws

• 4 blade shield screws

• 1 cupped washer

• 1 large nut for installing blade

• 1 long hex wrench

• 1 short hex wrench

• 1 upper handlebar cover bracket

• 1 shield for use with blades

• 1 shield for use with trimmer head

• 1 trimmer head

• 1 shoulder strap with warning

• 1 weed blade

• 1 brush blade

• 1 handlebar

• 1 container of oil

ACTUAL SIZE HARDWARE

Tube Mounting

Screw

Cupped Washer

Blade

Shield

Screw

Large nut for installing Blade _' C"_j '_

_ Tube Mounting

Nut

Handlebar Screw

Examine parts for damage. Do not use

damaged parts.

NOTE: If you need assistance or find

that parts are missing or damaged, call

] -800-235-5878.

It is normal for the fuel filter to rattle in

the empty fuel tank.

Finding fuel or oil residue on muffler is

normal due to carburetor adjustments

and testing done by the manufacturer.

ASSEMBLY

WARNING: If received assembled,

repeat all steps to ensure your unit is

properly assembled and all fasteners

are secure.

TOOLS REQUIRED

In addition to the 2 hex wrenches pro-

vided with your unit, you will need an

adjustable wrench.

ATTACHING THE TUBE

NOTE: Illustrations within this section

will help in identifying the assembly

steps. Be sure to read each section

and review the illustrations before you

begin. Align the engine with the fuel

cap up as shown below.

NOTE: A drive shaft is located in the

center of the tube. Make sure this shaft

does not fall out of the tube. Dirt on the

shaft will significantly reduce the life of

the unit. If this shaft falls out, clean, re-

lubricate, and re-install.

• Using a hex wrench, insert the 2 tube

mounting screws and nuts as illus-

trated. Keep loose at this time; you

will tighten them during a later step.

• Some units may include a plastic

cover over the end of the tube. If

your unit includes a cover, remove it

by pulling the tab.

• Pull about 1/2 inch of the drive shaft

out of the inside of the tube.

_Pull about inch from tube

1/2

Tube

NOTE: The square end of the drive

shaft fits inside a square hole in a shaft

inside the engine. Look inside end of

engine and you will see the square

hole in shaft. Align square end of the

drive shaft with the square hole.

5

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments