Craftsman 139.53225SRT1 Owner's Manual download pdf (Page 33)

Children operating or playing with a garage

door opener can injure themselves or others.

The garage door could close and cause

serious injury or death.

Do not allow children

to operate the wall push button(s) or remote

control(s).

A moving garage door could injure or kill

someone under it.

Activate the opener only

when you can see the door clearly, it is free of

obstructions, and is properly adjusted.

Your 53000SRT series garage door opener (with

receiver "SRT" button) has been factory set to

operate with the

large

push button on the remote

control(s). However, you can use either of the two

small buttons, if you prefer. And, the 3-function

remote control(s) can also activate additional

garage door openers and/or light controls.

Below are instructions for programming your opener

to match the other buttons on your remote controls

and any additional remote controls you may

purchase. See available accessories on page 38.

Your "SRT" garage door opener will operate with as

many as four "SRT" portable remote controls and

one Multi-Function Keyless Entry.

To Add A Remote Control

1. Select a remote control push button to operate

the receiver.

2. Press and

hold

the selected remote control push

button, Figure 1.

3. Then press and release the "SRT" button on the

right side panel of the opener in Figure 2. The

opener light will

flash once.

Now the opener will operate when the remote

control push button is pressed.

If you release the remote control push button

before the opener light flashes, the opener will

not accept the code.

To Change the Selected Push Button

On the Same Remote control

If you decide to use a different remote control button

than originally programmed into the opener, you

must erase

all

the learned codes and reprogram

each remote control used to operate the garage

door opener.

To Erase All Remote control Codes

• Press and hold the "SRT" button on the opener

panel until the indicator light turns off (about 6

seconds).

All

the codes the opener has learned

will be erased.

• To reprogram, repeat Steps 1, 2 and 3 for each

remote control in use.

Select a remote control push

button to operate opener

Mini 3-Function

Remote Control

Standard 3-Function Remote Control

Garage Door Opener

(With "Smart" Button)

END PANEL

"SRT"

Button

Indicator

Light

53000SRT Series Garage Door Openers

(With "SRT" Button)

Code programming instructions are also located

on the opener panel.

WARNING

Figure 1

Figure 2

Receiver and Remote Control Programming

To comply with FCC rules, adjustment or modifications of this receiver

and/or transmitter are prohibited, except for changing the code setting or

replacing the battery. THERE ARE NO OTHER USER SERVICEABLE

PARTS.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

Craftsman 139.53225SRT1 Owner's Manual Page 33

Comments to this Manuals

Related products and manuals for Garage Door Opener Craftsman 139.53225SRT1