Craftsman 139.53225SRT1 Owner's Manual download pdf (Page 18)

Installation Step 6

Install the Deluxe Lighted

Console Wall Control

Children operating or playing with a garage

door opener can injure themselves or others.

The garage door could close and cause

serious injury or death.

Install the Wall Control (or any additional push

buttons) out of the reach of children and away

from all moving parts of the door and door

hardware,

but where the garage door is visible.

Do not allow children to operate the push

button(s) or the remote control(s).

A moving garage door could injure someone

under it.

Activate the opener only when the

door is properly adjusted, you can see it

clearly, and there are no obstructions to door

travel.

Antenna

Lighted

Push Bar

Wall Control

Terminal Screws

Opener

Terminal Screws

LOCK

LIGHT

SEARS

/CRAFTSMAN

WHITE

RED

2 3

• Strip 1/4" of insulation from one end of the bell

wire; connect the wire to the two screw terminals

on the back of the Wall Control: white to 2, and

white/red to 1.

• Locate the Wall Control within sight of the door

at a minimum height of 5 feet where small

children cannot reach, and away from all

moving parts of the door and door hardware.

Fasten the Wall Control securely with 6ABx1"

screws. If installing into drywall, drill 5/32" holes

and use the anchors provided.

• Run the bell wire up the wall and across the ceiling

to the opener. Use insulated staples to secure the

wire in several places. Be careful not to pierce the

wire with a staple, thereby resulting in a short.

• Receiver terminal screws and the antenna are

located on the right side panel of the opener.

Position the antenna wire as shown.

• Then connect the bell wire to the opener terminal

screws: white to 2; white/red to 1.

• Remember to affix the User Safety Instruction

label to the wall near the Wall Control, and the

Maintenance Instruction label in a prominent

location on the inside of the garage door.

If the label adhesive will not adhere to your garage

wall surface (or becomes loose with time) use tacks

to secure the label alongside the Wall Control.

Page 32 explains how to operate the opener using

the lighted push bar and the Lock & Light features

available on the Deluxe Lighted Console Wall

Control.

Screw

6ABx1"

Dry Wall Anchors

Insulated

Staples

Hardware Shown Actual Size

Outdoor Key Switch Accessory Connections

To opener terminal screws: white to 2; white/red to 1

WARNING

Do NOT connect the power and operate the

opener at this time.

The trolley will travel to the

full

open

position but will not return to the

position until the sensor beam is connected and

properly aligned.

See Safety Reversing Sensor Instructions

beginning on page 21.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments

Craftsman 139.53225SRT1 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Garage Door Opener Craftsman 139.53225SRT1